Start-up

Note: The power tool is optimised for cutting depths of up to 1 mm.

The cutting depth can be continuously adjusted from 0–1.0 mm using the knob (1). For cutting depths greater than 1 mm, the button (2) must be pressed:

Material

Planing width in mm

Cutting depth in mm

0–1.0

0–2.0

Softwood

< 30

●

●

30−40

●

−

Hardwood

< 20

●

●

20−30

●

−

Softwood (wet)

0−40

●

−

Plywood

< 20

●

●

20−30

●

−

Phenolic resin-coated plywood

< 15

●

●

15−30

●

−

MDF sheets

< 20

●

●

20−30

●

−

Veneers

1

●

●

Hardwood veneers

3−5

●

●

Two-part filler

3−5

●

●

Cardboard

2

●

●

Insert the charged battery (5) into the battery holder until it is flush and you feel it engage.

  • Make sure that you are able to press the On/Off switch without releasing the handle.

To start the power tool, first press the lock-off switch (3), then press and hold the on/off switch (4).

To switch off the power tool, release the on/off switch (4).

Note: For safety reasons, the on/off switch (4) cannot be locked; it must remain pressed during the entire operation.

When the on/off switch (4) is pressed in halfway or completely, the battery charge indicator (10) indicates the battery's state of charge for several seconds. The indicator consists of three green LEDs.

LEDs

Capacity

3× continuous green light

≥66 %

2× continuous green light

≥33 %

1× continuous green light

<33 %

1× flashing green light

Reserve

In the event of an overload, the speed is reduced. Allow the power tool to cool down unloaded at its maximum no-load speed for approx. 30 seconds.