Start-Up
Switching On/Off
To start the power tool, push the unlocking lever (9) forwards and then push the on/off switch (8) up.
To switch off the power tool, release the on/off switch (8).
- Always check abrasive tools before using them. The abrasive tool must be fitted properly and be able to move freely. Carry out a test run for at least one minute with no load. Do not use abrasive tools that are damaged, run untrue or vibrate during use. Damaged abrasive tools can burst apart and cause injuries.
Connectivity functions
In conjunction with the Bluetooth® Low Energy Module GCY 42, the following connectivity functions are available for the power tool:
- Registration and personalisation
- Status check, output of warning messages
- General information and settings
- Management
Read the corresponding operating instructions for information about the Bluetooth® Low Energy Module GCY 42.