Transporting the Power Tool (see figure W)

Remove the battery from the power tool before carrying out work on the power tool (e.g. maintenance, changing tool, etc.). The battery should also be removed for transport and storage. There is risk of injury from unintentionally pressing the on/off switch.

Before transporting the power tool, the following steps must be carried out:

Loosen the locking screw (1) if it is tightened. Pull the tool arm fully forwards and retighten the locking screw.
Ensure that the depth stop (39) is swung all the way back and the adjusting screw (38) does not touch anything when you move the tool arm.
Bring the power tool into the transport position.
Remove all accessories that cannot be securely fitted to the power tool. If possible, transport unused saw blades in an enclosed container.
Turn the transport handle (3) so that it is vertical.
Carry the power tool by the transport handle (3) or hold it by the recessed handles (61) on the sides of the saw table.

Only use the transport devices to transport the power tool and never the protective devices or workpiece supports.