Selecting the working mode

GDS 18V-350

The power tool has one predefined working mode: Automatic shutdown (ABR).

Set the power tool to anticlockwise.
Press the mode button (12) to activate the automatic shutdown (ABR) working mode.

If the automatic shutdown (ABR) working mode is activated, the automatic shutdown indicator (ABR) (11) lights up.

When undoing nuts, press the on/off switch (7) as far as it will go in order to trigger the automatic shutdown (ABR).

The previous setting is retained when the battery is changed.

Note: The automatic shutdown (ABR) indicator (11) lights up only when the automatic shutdown (ABR) is switched on. The power tool must rotate in an anticlockwise direction.

Note: The automatic shutdown (ABR) works only if bolts or nuts are securely tightened. The on/off switch (7) must be fully pressed.