Assembling the Saw Stand
Carefully remove all parts included in the delivery from their packaging.
Remove all packing material.
Setting Up the Saw Stand (see figures A1–A2)
- Place the saw stand on the floor with legs up.
- Press the locking pin (19) in and swivel the leg up until the locking pin audibly engages again.
Repeat this work step with the other three legs. - Rotate the saw stand into the working position.
Make sure that the saw stand is stable and all locking pins have engaged.
A height-adjustable foot (9) helps you to align the saw stand.
- Undo the lock nut (20) and screw the foot in or out until the saw stand is level and all four legs are on the ground.
Fitting the Length Stop and Workpiece Support (see figures B1−B2)
- Screw together the length stop (5) and the workpiece support (1) with the bolt (11) and the locking knob (4).
- Insert the workpiece support (1) into the table extension (2).
- Pull the locking knob (7) to lock the workpiece support.
- Repeat these steps with the second workpiece support.