Changing the Tool

Before carrying out any work on the power tool (e.g. maintenance, tool change etc.), remove the battery from the power tool. There is risk of injury from unintentionally pressing the on/off switch.

Pull the locking sleeve (2) forward, guide the application tool into the tool holder (1) up to the stop and release the locking sleeve (2) to lock the application tool.
Screwdriver bits (13) can be inserted using a universal bit holder with ball catch (12).

Pull the locking sleeve (2) forward and remove the application tool.

When working with an application tool, pay attention that the application tool is connected securely to the tool holder. When the application tool is not securely connected with the tool holder, it can come off during application.

Slide the application tool (14) onto the square drive of the tool holder (1).

Due to the way the system operates, the application tool (14) will move around slightly in the tool holder(1); this has no influence on the function/safety.

Changing the Tool

GDR 120-LI:

Inserting the application tool (see figure B)

Removing

GDS 120-LI: (see figure C)